top of page

Asphalt or concrete driveway: which is better in the Fraser Valley?

Writer: Zeb Van Spronsen
Zeb Van Spronsen
Nov 2
6 min read

Concrete typically lasts 30 to 40 years and costs more up front. Asphalt typically lasts 15 to 20 years, costs less to install and is ready to drive on in a day or two. In the Fraser Valley's wet climate, either one fails early if the gravel base underneath is soft or poorly drained.

If you're replacing a cracked, sinking or potholed driveway in Langley, Abbotsford or Chilliwack, the surface is only half the decision. Below we compare the two, explain what drives the price and show why the ground under your driveway matters most. If you'd rather talk it through on site, book a free assessment with ZVS.

Asphalt vs concrete


Asphalt

Concrete

Typical lifespan

15–20 years

30–40 years

Up-front cost

Lower

Higher

Ready to drive on

Usually 1–2 days

Usually about 7 days; full strength takes around 28 days

Regular upkeep

Seal every 2–3 years and fill cracks

Clean it; sealing is optional

How it handles ground movement

Flexes a little, so small shifts are less likely to crack it

Rigid, so it cracks where the ground settles or heaves

Repairs

Patches and overlays are fairly easy

Cracks and patches are harder to hide

Looks

Plain black

Broom, stamped, coloured or exposed aggregate finishes

The short version: asphalt is the budget-friendly choice that needs more care over time. Concrete costs more once and then mostly looks after itself, as long as the ground under it stays put.

Which one lasts longer in the Fraser Valley?

Concrete lasts longer, typically about twice as long as asphalt. But our winters are more about rain than deep frost, and water is what shortens the life of both.

  • Asphalt: Rain and sun slowly dry out the surface. Once cracks open, water gets into the gravel base, softens it and turns small cracks into potholes. Sealing every 2–3 years and filling cracks early keeps that water out.

  • Concrete: It doesn't mind rain on top. The problem is water underneath. If the base stays soggy, the slab settles unevenly and cracks, and on shaded driveways moss and slippery algae can build up on the surface.

  • Both: Driveways on the wet clay and silt common around Langley, Abbotsford and Chilliwack need water moved away from them. Puddles that sit along the edges are a sign the drainage isn't working.

If your property already has water problems, read our guide on why poor drainage is quietly destroying Fraser Valley properties before you pick a surface.

What drives the cost of replacing a driveway?

Two driveways the same size can be priced very differently. These are the things that move the number most:

  1. Size and shape. More square footage means more material. Curves, flares and turnarounds add forming and labour.

  2. Tearing out the old driveway. Breaking up concrete, especially with rebar or mesh in it, takes more time and equipment than lifting old asphalt. Trucking it away and disposal fees add up.

  3. The condition of the base. If the old gravel is still firm, it may only need topping up and compacting. If it's mixed with mud or sitting on soft clay, it has to be dug out and rebuilt.

  4. Drainage work. Regrading, adding a culvert where the driveway crosses a ditch, or installing drains to stop water pooling all add to the job.

  5. Access and slope. Tight lots, steep grades and long rural driveways take more time and sometimes smaller equipment.

  6. The finish you choose. Plain broom-finish concrete costs less than stamped, coloured or exposed aggregate.

  7. Permits and inspections. Work where your driveway meets the road can need a municipal permit and fees.

A low quote often saves its money on number 3. That's the part you can't see once the new surface is down, and it's the part that decides how long your driveway lasts. Want a price for your property? Get a free site assessment.

Why the base matters more than the surface

Most driveway failures start in the ground, not in the asphalt or concrete. The surface just shows what's happening underneath.

A driveway that lasts is built in layers:

  1. Dig out to firm ground. Topsoil, roots and soft, wet material are removed. Organic soil left under a driveway keeps breaking down and settling for years.

  2. Stabilize soft subgrade. On wet clay, a geotextile fabric is often laid down first so the gravel doesn't sink into the mud.

  3. Build up crushed gravel and compact it in layers. Thin layers, each one compacted, give a solid base. One thick dump of gravel never compacts properly.

  4. Grade for water. The base is shaped so rain runs off the driveway and away from your house and garage, not along the edges or under the slab.

This is excavation and site prep work, which is what we do every day. You can read more about it in our guide to residential excavation in the Fraser Valley, or see everything we offer on our services page.

Can you pave over an old driveway?

Sometimes, but only if what's underneath is still sound. Here's how to tell:

  • An overlay can work when an asphalt driveway is mostly flat, drains well and only has fine surface cracks. A new layer of asphalt over it can buy you years.

  • It needs to come out when you see sinking, soft spots, potholes, wide cracks that keep spreading or water pooling. Those mean the base has failed, and new material laid on top will crack in the same places.

  • Concrete over concrete is rarely worth it. Cracks and settling in the old slab tend to show through the new one.

If you're not sure which you have, a quick look at the edges and low spots usually tells us. Full removal is also the time to fix drainage and widen or reshape the driveway. Taking out an old slab is demolition work, and our article on building demolition covers how we handle tear-out and debris removal.

Do you need a permit to replace a driveway?

Usually not for the part on your own property. You often do for the part that meets the road. The strip between your property line and the street, including the ditch on rural roads, belongs to the municipality.

  • Township of Langley: Installing a driveway that crosses a roadside ditch goes through the Township's driveway application. The Township sets the culvert size (300 mm minimum), and the pipe has to be inspected before it's backfilled. Any work in the road right-of-way also needs a Highway Use Permit.

  • Abbotsford and Chilliwack: Both have their own street bylaws. Call the city's engineering department before you change the driveway entrance, the curb or a culvert.

  • Ditches with fish habitat: If the ditch is a protected watercourse, there can be environmental review and set times when work is allowed.

A good contractor checks this before the job is booked, so you aren't stuck with a half-finished driveway waiting on an inspection.

A recent ZVS driveway job

On a rural property in Langley, the old concrete driveway had sunk along one edge where water pooled every winter. We tore it out, dug the soft clay down to firm ground, laid fabric and rebuilt the base with compacted crushed gravel graded toward the ditch. The new surface went down on a base that drains.


Frequently asked questions

Is asphalt or concrete cheaper for a driveway? Asphalt is typically cheaper to install. Concrete costs more up front but usually needs less upkeep and lasts longer, so the gap narrows over the life of the driveway.

How long does it take to replace a driveway? Tear-out and base prep often take a few days, depending on size and site conditions. After that, asphalt is usually drivable in 1–2 days, while concrete needs about a week before you park on it.

Why is my driveway sinking? Sinking almost always means the base underneath has softened or washed out, usually from water. Resurfacing won't fix it; the soft material has to come out and the base has to be rebuilt.

Do I need to replace the whole driveway or just part of it? If the damage is in one area and the rest is solid, a section can sometimes be cut out and rebuilt. If problems show up across the driveway, full replacement is usually better value.

Can I park an RV or work truck on a new driveway? Yes, if the base is built for it. Tell your contractor about heavy vehicles before the job starts so the gravel base and slab are sized for the load.

Ready to replace your driveway?

Whether you go with asphalt or concrete, the job starts with what's under it. ZVS Operations handles driveway tear-out, excavation, base prep, grading and drainage across Langley, Abbotsford, Chilliwack, Mission and Maple Ridge, and we'll help line up the right crew for the surface. Book your free site assessment or learn more about ZVS Operations.


 
 
 

Comments


Commenting on this post isn't available anymore. Contact the site owner for more info.
bottom of page